Security Link SL150 Guida alla Risoluzione dei Problemi Scaricare il pdf (Pagina 90)

SL150 Installation and Setup Guide

16–8

ENTER START ZONE

00 = QUIT 36

Example of zone

↑

suggested by

the

system. This indicates

that zones 36, 37, 38,

and 39 are available.

6. The system will search for the highest zone number available,

subtract the number of consecutive zones required for the

device (four zones in the case of the 5804 and 5804BD), and

display the lowest zone number of the group.

If you want to start at a different zone, enter the zone desired,

and press [

✱].

If that zone number is displayed, the system has the required

number of consecutive zones available, beginning with the zone

you entered. If not, the system will again display a suggested

zone that can be used.

If the required number of consecutive zones is not available at

all, the system will display “00”.

7. Press [

✱

] to accept.

INPUT S/N L

AXXX-XXXX –

8. Enter the serial number for the wireless key or fault and

restore zone to transmit serial number.

9. Press [

✱

] to accept the serial number. The system will check for

duplicate.

10. If necessary, press the [#] key to back up without saving, and

re-enter the serial number.

Use the [A] key to move forward within the screen, and the [B]

key to move backward.

XMIT TO CONFIRM

PRESS

✱

TO SKIP

11.

If “Yes” was entered at the SET TO CONFIRM? prompt

previously (see first prompt following entry into the

✱

Expert Programming Mode on page 16-4), the display on the

left will appear. Confirm serial and loop numbers by activating

the wireless key.

If the serial number transmitted does not match the

serial number entered, a display similar to the one below

will appear. If the loop number does not match, it will also be

displayed.

Entd A022-4063

Rcvd A022-4064 1

If so, activate the loop input or button on the transmitter

once again. If a match is not obtained (i.e., summary display

does not appear), press the [#] key and then enter the

correct serial number.

If the serial number transmitted matches the serial

number entered, the keypad will beep 3 times and will

return you to step 6 above to enter the starting zone for the

next wireless key.

NOTE: Following the successful enrollment of each wireless device, remove ONE of the serial

number labels from the device and affix it in the appropriate column on the ENROLLED

TRANSMITTERS worksheet of the Programming Form; then enter the other information (zone

number, zone type, loop number, etc.) relevant to that device.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 143 144

Commenti su questo manuale

Nessun commento

Security Link SL150 Guida alla Risoluzione dei Problemi Pagina 90

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Security Link SL150