Security Link SL150 Guida alla Risoluzione dei Problemi Scaricare il pdf (Pagina 86)

SL150 Installation and Setup Guide

16–4

To Delete a Serial

Number

→

To delete an existing serial number, enter 0 in the loop number

field. The serial number will change to 0's.

10 INPUT S/N:

A000-0000 0

If 0 was entered in error, simply re-enter the loop number or

press [#], and the serial number will return to the display.

Zn ZT RC In: L

10 03 10 RF:

If the serial number transmitted matches the serial

number entered, the keypad will beep 3 times and a summary

display will appear, showing that zone's programming. Note that

an “s” indicates that a transmitter’s serial number has been

enrolled.

Press [

✱

] to accept the zone information and display the

PROGRAM ALPHA? prompt.

PROGRAM ALPHA?

0 = NO 1 = YES 0

If you want to program descriptors for zones now, enter 1 (Yes) and

refer to Section 19: Alpha Descriptor Programming for

available descriptors.

ENTER ZN NUM.

(00 = QUIT) 11

(No) was entered above, the system will return you to the

ENTER ZN

NUM.

prompt for the next zone.

When all zones have been programmed, enter

to quit

When you have finished programming all zones, test each zone using the system’s TEST mode.

Do not use the Transmitter ID Sniffer Mode for checking wireless transmitting devices

, as

it will only check for transmission of one zone on a particular transmitter, NOT the zones

assigned to each additional loop.

NOTE

Following the successful enrollment of each wireless device, remove ONE of the

serial number labels from the device and affix it in the appropriate column on the

ENROLLED TRANSMITTERS worksheet in the Programming Form; then enter the other

information (zone number, zone type, loop number, etc.) relevant to that device.

✱

58 Expert Programming Mode Procedures

Enter the program mode and follow the step-by-step instructions that follow.

Note: Before proceeding, you must program field

✱

22 (RF System) and field

✱

25 (Wired Zone

Expansion) as required.

SET TO CONFIRM?

0 = NO 1 = YES 0

Press

✱

58. This display will appear upon entry into this mode.

The default is 0 (No).

If 1 (Yes) is entered, you will be prompted to confirm each

transmitter after entering the serial and loop numbers (at the

“XMIT TO CONFIRM” prompt later).

ZT RC IN: L

01 09

10 HW: 1

A summary screen will appear, showing zone 1’s current

programming or default values.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 143 144

Commenti su questo manuale

Nessun commento

Security Link SL150 Guida alla Risoluzione dei Problemi Pagina 86

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Security Link SL150